DIB, for visualizing states are supplied with the controller in German. Each time the heatsealing band is replaced, the zero point must be calibrated with the AUTOCAL function while the band is still cold, in order to compensate production-related resistance tolerances. Switch off the line voltage and verify that the circuit is de-energized. The temperature calculated with the help of these measurements is displayed and compared with the set point. RES Controller functions This relay is set in the factory as follows: The use of a suitable line filter is part of the!
| Uploader: | Mujind |
| Date Added: | 24 January 2010 |
| File Size: | 54.73 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 94491 |
| Price: | Free* [*Free Regsitration Required] |
We will be pleased to contribute our many years of experience towards optimizing your heatsealing system. These features assist the operator in identifying the cause of abnormal operations. The real heatsealing band temperature can thus be displayed on an external temperature meter e.
Installation and maintenance may only be performed by technically trained, skilled persons who are familiar with the associated risks and warranty provisions. It is the responsibility of the machine manufacturer and of the user to verify the completely installed, wired and operationally ready system in the machine with regard to its conformity with the safety provisions and the EMC directive see also section 8.
Operating instructions RES-406 - About
Invalid error messages may appear when the controller is switched off owing to the undefined operating state. RES Page 23 Controller functions Proceed as follows to start up the controller for the first time: In addition, the actual value is no longer updated.
ropes
If you want vsiualization use all features of the controller make sure that the appropriate version of the device master file is used. This may be interpreted by the higher-level controller e.
The 2x16bit input data contains the set point in word c and the control functions in word d: The zero point must therefore be RES Startup and operation corrected after a few heating cycles, i. The relevant safety instructions contained in section 8.
We shall therefore only refer to a few of the most important physical and electrical properties: It does not go out again until it detects an active communication. Make sure that the wiring conforms to the relevant national and international installation regulations. Action if machine already operating, HS-band not chang. The heatsealing band must be replaced in softwafe with the instructions provided by rkpex manufacturer.
One very important design feature is the copper or silver-plating of the heatsealing band ends. A new setting does not take effect until the next time the controller is switched on.
If the parameter data is changed during operation, the RES performs a reset. The use of incorrect alloys with a too low temperature coefficient and incorrect coding of the RESISTRON temperature controller lead to uncontrolled heating and ultimately to burn-out of the heatsealing band! Wire the system in accordance with the instructions in section 8.
This can take several ms. Impulse transformer 24V IN U2 sec.
Trailing cable, halogene und silicone free. An soffware or burned-out heatsealing band must no longer be used because the TCR has been altered irreversibly. They are not included in the scope of supply of the standard control system and are described in a separate document. RES Page 9 Dimensions Other transformers may cause the equipment to malfunction. They allow it to be optimally adapted to your specific heatsealing application and to your plant's design and operating philosophy.
The meter damping vishalization the unit is optimized for the abrupt temperature changes that occur in impulse mode.
All ROPEX technical documentation as free downloads - ROPEX Industrie-Elektronik GmbH
Ensuring such compliance is the personal responsibility of the user. The table below shows how the analog voltage values correspond with the faults that have occurred. The recommendations and warning notes contained in these operating instructions must be complied with, in order to guarantee safe operation.
No comments:
Post a Comment